Shinko Technos SE2EA-1-0-0 Manuel d'instructions télécharger pdf (Page 18)

- 18 -

Load

Inductive load (coil)

Varistor, CR circuit, etc.

Load

Diode, varistor,

CR circuit, etc.

Inductive load (coil)

4.3 Wiring of Terminals

Warning

• For 100 to 240V AC, if AC power source is connected to incorrect terminals,

this instrument will burn out.

• For a 24V DC power source, do not confuse polarity when wiring.

4.3.1 Power Source Wiring

Use terminals 13 (+) and 14 (-) for the power supply to the instrument.

4.3.2 Output Wiring

SE2 A: Use terminals 9 (+) and 10 (-) for CH1 A1 output wiring.

Use terminals 11 (+) and 12 (-) for CH2 A1 output wiring.

SE1 A: Use terminals 9 (+) and 10 (-) for A1 output wiring.

Use terminals 11 (+) and 12 (-) for A2 output wiring.

Take the following measures for contact protection and noise reduction of A1

output relay.

AC Power

(Fig. 4.3.2-1)

DC Power

(Fig. 4.3.2-2)

For 6-points output specification, alarm output connectors are attached at the

top of the unit. Refer to the alarm output corresponding to the connector number.

(Table 4.3.2-1)

Alarm OutputConnector

Number

SE2 A SE1 A

1 CH1 A2 output A3 output

2 CH1 A3 output A4 output

3 CH2 A2 output A5 output

4 CH2 A3 output A6 output

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Pas de commentaire

Shinko Technos SE2EA-1-0-0 Manuel d'instructions Page 18